Visionman SCM200 Guía de usuario descargar pdf (Pagina 5)

Rear View 2 & 4 DRIVE USER GUIDE

Page 5 of 57

Power Button: Press the power button to turn the SCM200/SCM400 on. The Green LED under the button will

indicate that the system is powered on. Press and hold the button to power the system down. If the LED is off,

then it indicates that either the system is still initializing or the system is not powered on. A blinking LED indicates

either the system is rebooting or the RAID is rebuilding, and will be unavailable for file sharing or administration during this

time.

Network Activity Indicator: The green LED under or next to this icon indicates a network connection. The blinking

of this LED indicates network traffic. When this LED is off, this indicates there is no network connection.

HDD Status Indicator: The blinking green LED’s indicates formatting, accessing or synchronization of the individual

drives. The solid green light indicates that the system is completely synchronized and is ready to use. And amber

LED indicates a drive error or an old HDD has been installed with data on it. When this LED is OFF, it means that the

drive is not installed correctly or has completely failed.

System Identification: This blue LED indicates that system identification is active. When this LED is off it indicates

that system identification is disabled. A blinking LED means there us a critical condition.

USB Backup Status Indicator: This green LED lights to indicate that a USB hard drive is attached, and the system

is rebuilding, restoring, or transmitting files to the USB drive. A blinking LED indicates that the system is backing up

the USB hard disk or that the system is formatting the drive.

Rear View

The functionality of the connections on the back is the same between the SCM400 and the SCM200.

USB Port: The SCM400 has three USB ports, two in the back and one in the front. The SCM200 has two USB

ports in the back. These ports allow for the connection of USB devices like a USB hard drive, a USB flash drive,

or a USB printer.

Ethernet Port: This port connects the SCM200/SCM400 to the local network.

Reset Switch: Press the Reset button to restore the SCM200/SCM400 to factory settings. The button is recessed and

located above the Ethernet port on the SCM400 and between the power connector and Ethernet port on the SCM200.

1 2 3 4 5 6 7 8 9 10 ... 56 57

Sin comentarios

Visionman SCM200 Guía de usuario Pagina 5